Keen-One 組み立て方法

DIYハーモニック赤道儀

3Dプリントさえ完了すれば、2時間もあれば組み立てられると思います。

難しいところは最後のギアを合わせるところです。ギアの位置を下記のようにします。内歯が外歯より一つ少ないので赤いラインの部分だけ噛み合っていません。それ以外は噛み合っている状態です。

MainHousing.stlには、12箇所インサートナットを埋め込みます。インサートナットの埋め込み方を動画にしました。最初に映せば良かったですが、下穴が必要です。このインサートナットはM4でギザギザの部分が外径6mm、凹んだ部分の外径が5mmです。この場合下穴のサイズは、中間の5.5mmが収まりが良いです。

関連記事

特集記事

コメント

  1. おはようございます。

    メーカー製品でもなかなか無い綺麗な説明書ですね!

    >内歯が外歯より一つ少ない

    先日うかがってから考えていたのですが、 明らかに内歯のギヤが円周方向に伸縮しているので
    回転ムラが心配です。(2歯減の場合は直径方向の変形で噛み合っています。)

    まあ2歯減にするのは内歯のギヤだけ作り直せば、あとはベアリングを4つ外してモーターのスピードを
    半分にするだけなので簡単ですね!

    • KEN
      • KEN
      • 2022.08.16 1:01am

      こんにちは!
      今のところ心配するほどの回転ムラは出ていません。
      相変わらず大雨で検証できてませんが・・・

      1:78の減速比が欲しかったので今回は敢えて1歯減にしました。2歯減にすると1:39になってしまうので。OnStepで推奨している減速比に近づけたかったのが理由です。

      いずれにしても、検証すれば何かが分かるはずです。

    • Pololamag
    • 2022.09.16 3:32am

    Hello Ken,
    Your equatorial mount looks really good, it’s a great remix of the HrEM from Mr RomanHujer. I started to build it on my side. I’d like to adapt it to my needs, especially with modifications on the M4 screws locations, and the sturdiness of the whole. Do you think you can share the FreeCad or Solidworks design files, like for the HrEM?
    Also, would you be able to share more of the astro shots you were able to take with it? And the performance you manage to get?
    Many thanks,
    Polo

    • KEN
      • KEN
      • 2022.09.20 4:08pm

      Hi Polo,
      I will now prepare and publish the STEP data. I need to organize the file names, etc. because only I can understand the data, so please give me some time.

      As for the photos I have taken, there were not many starry nights this summer in Japan, so I will be taking and uploading them from now on. However, the weather is unstable because of the visiting typhoon season. It is really stressful every day.

TOP
WP2Social Auto Publish Powered By : XYZScripts.com